Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sahilnabi
Relay is basically an electronic device which manufact because of sensing very small parameters of electricity.
In connectivity of the same contactor is made for basically for manual as well as automatic switching operation for secure the machine from several surges.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Difference between megger test equipment and contact resistance meter test instruments?
what is the practical application of full adder circuit?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
How to calculate the sag of OPGW during stringing???
Is there any specialised book to refer about fault level calculation both in MV and LV side??
what is ratio of copper wire size and current ?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
how give earthing conection to household equipment?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
give me applications of sequence bridges . (used in 3 phase un balanced systems)
How would you relate your key competencies to this position?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
why co incidence factor considered in transformer sizing?
What are the material used for inductance coil?
