Interested to Buy Any Domain ? << Click Here >> for more details...
what is reactive power
is it good or bad for a system
- 5 Answers
- 16322 Views
- I also Faced
- E-Mail Answers
Answer Posted / n.krishnaswamy
When power factor decreases more power is drawn and energy charges will increase.So power factor is to maintained near to unity.In our state,for an HT consumer, if power factor is less than 0.9 there will be exorbitant fine.I f it is maintained above 0.95,we will get good incentive.In one of my project, the total energy cost is Rs.17 lakhs. Since the power factor is maintained 0.99, the incentive is Rs.83000/-
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the function of the circuit breaker failure relay?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
what are types of encoder
How grounding is different than earthings?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Why colled 440V to 3-phase supply.
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
The height to which the liquid in a tank to be maintained for a certain constant velocity?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
