Interested to Buy Any Domain ? << Click Here >> for more details...
1. what is 3 point calibration & 5 point calibration?
2. If we use hart communicator to set the LRV & URV of a
smart transmitter, did we calibrate the transmitter? why?
3. Make a complet list if meterials needed to properly
connect a pressure gauge to a steam pipe using 1/2 inch
stainless steel tubing. The gauge connections is 1/2 inch
NPT-M and the steam pipe tap has a 1/2 inch female coupling,
compression fittings are use.
4. What are the tools in loop checking?
5. What would the ISA symbol of a square root extractor look
like?
6. What would you do to completely prepare for the
configuration?
7. What safety measures must you undertake when doing
configuration?
8. what are the two most commonly use programming languages
used when we configure a PLC?
9. What would you do if you accidentally skipped a step in
the configuration procedure?
10. How would you know if the configuration were sucessful?
11. Name at least 3 selections available when we configure
the burnout protection of a controller?
- 3 Answers
- 36378 Views
- EI Electrotechnical Institute, I also Faced
- E-Mail Answers
Answer Posted / bhoorzky
In bench calibration,what is the function of a resistor
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
how many type conductivity sensor ?
applications of plc in printing and packaging?
How to check vortex flow meter is in good condition while we do not having calibration setup?
What is the PLC configuration in Cement industry?
How earthing can be checked????
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
what are the steps I have to deal with?
What is Positive Calibration and Negative Calibration?
What is the use of temperature compensation?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
how to measure draft pressure in transmitter pl. give its single line digram
