Piezoelectric materials serve as a source of:-
A. Microwaves B. Ultrasonic waves
C. Musical waves D. Resonant waves
- 3 Answers
- 8400 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar
B. Ultrasonic wave
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
dear all i am kumara now current working in electrical designing of control and relay panel i want learn some substaion design then any book are available. pls mention name and authour
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
State norton’s theorem?
What is the most important precaution in any experiment with d.c. Shunt motor?
what is doubling factor in making current of a breaker?
solar energy light efficiency & disadvantages?
what is ramping rate of generator
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
What is knee point voltage of transformer?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
where solid grounding and where grounding through ngr done and why?
