Interested to Buy Any Domain ? << Click Here >> for more details...
The insulation resistance of a cable can be measured by
- 3 Answers
- 5275 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepikawalde
A very significant maintenance procedure for checking out the working condition of an electrical system is called IR test or Insulation resistance. It can be said that ht system or equipment is fine when insulation resistance is high.
Megger is an insulation resistance measurement tools for finding the equipment’s insulation resistance. Let us see how is the IR calculated?
Define Insulation resistance
There is an application of direct current (DC) and not alternating current (AC) and this is the first thing while doing the Insulation resistance test. for more :- http://crbtech.in/Electrical-Training/index.php/2017/07/31/define-insulation-resistance-and-its-calculation/
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
how choose conductor&depending upon load
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
Power Factor Correction Panel (Manual & Automatic)
Why use the vcb at high transmission system ? Why can’t use acb?
Why Stabilising Resistor used in REF circuit ?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
What is cable tray, its type, and its support?
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
what is the difference between neutral and earth
how can you size an automatic voltage regulator?
How does an oscillator differ from an amplifier?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
