Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hiren
Calibration procedure is verification of responds of instrument device against the non standandard instrument.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
kindly sent some demo question and answer
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
What are the interlocks we have to check during the start up of LP/HP compressor?
What is the use of temperature compensation?
Linear amplifier.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
How it the difference between force balance system and dispalacement balance system?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Please asked me How calculate DCS controller memory.
line up procedure for dp type flow transmitter?
What are different types of orifice plates?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Questions on flow meters,few questions on HART protocol,
How would you choose differential range?
