Interested to Buy Any Domain ? << Click Here >> for more details...
TRANSDUSER MOSTLY CONVERT WHICH ENERGY INTO ENERGY ?
- 6 Answers
- 8711 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / vitthal rathod
Transducer- convert physical quantity into electrical signal.
Sensor- convert physical energy into physical energy.
Transmitter- convert physical quantity into standard electrrical signal.
Converter- convert one STD signal into another STD signal.
STD signals
Electrical- 4 mA to 20 mA
1 v to 5 v dc
Pneumatic - 3 to 15 psi
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calibration a control valve?
Introduce yourself which is not present in your biodata?
How can measure flow in oil line?which type of transmitter is generally used?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
Gas equation
How many interlocks at turbine? Plz explain briefly
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How hart protocol can be connected with control valves?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
plz send me general of ongc
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
Which type of pressure can be measured by these elements?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
