Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ram
Hookup to indicate the how to install the instruments.whether it's stand mounting or direct mounting in this drawing shows dot and stand when the dot indicates direct mounting and stand indicates stand mounting
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
what is the difference between scaler and vector drive
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
draw the block diagram of a level transmitter ?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
flow transmitter formula?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what are the diff. in servo and regulatory control?
Explain the difference between mmwc and mmwg?
Explain the burnout feature.
