Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / varun
M20means
1bag cement (2tokri of cement)
1.5 sand (3 tokri of sand)
3 aggregate (6 tokri of bajri)
1:1.5:3
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the difference between 53 grade and 43 grade cement
For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.
what is constat for brickwork
Differentiate orthographic and isometric projections?
significance of specific surface area of particles?
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
Would you cause a 55-gallon drum of water to weigh more by climbing in?
what is the productivity in aluminium shuttering per day
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
in a building why we are using T beams? why can i adopt beam bottom & Top level as same as slab bottom & Top level?
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
What is the material consumption- cement,sand,tiles etc for Toilet dado?
how many monpower required for 1 sqm normal RCC structure ( includes finishes & MEP )
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
