Answer Posted / chanti
1.3
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are root loci?
What is meant by short-pitched winding?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
where we use the SFU & FSU?
what is plunger and what's the use of it in motor alignment?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
How to decide cable tray size?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
what is the difference between b c d curves on mcb
Difference between rating factor of cable and derating factor of cable?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
what is the reqirred voltage in HT motor to get full RPM on no load test?