Interested to Buy Any Domain ? << Click Here >> for more details...
If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
- 16 Answers
- 75590 Views
- BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / mukesh
it is not a three phase voltage is three times the single phase voltages. we only take a voltage between two points not between three points. so when we measure voltage between two points in single phase system there is one of its point at higher potential and other is at zero potential(reference point). but in the three phase system if we take a reference point and measure voltage between them (between reference and higher potentials) and adds up algebraically we got a voltage 400 v. if we also measure voltage between two higher potential we got 400v due to the wave forms of phases reaches at potentials according to time. but this not happens that both the voltage reaches at higher vale in the same instant. so its never been 660 v....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
how to find out 3 phase complex power in per unit in unbalanced system?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
direction of tarbine& genrator
what is the electrical?
what is meaning of bus riser
How they LT panel busbar size choose
what is stper motor
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
How to design pavement quality concrete by using C.R.C.P Method
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
how we provide neutral earth on synchronising panel as per electrical standards?
