Interested to Buy Any Domain ? << Click Here >> for more details...
why we use the 4-20 mamp signal used for transmitter.
- 5 Answers
- 10749 Views
- Tecnimont, I also Faced
- E-Mail Answers
Answer Posted / hossam nasr
From 4to20 ma is linear curve and it's suitable to calculate all values from zero to span
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is span value and zero ? and how set ?
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
I need to know steps to Calibration Valve Guard......
Difference between dcs and plc including date processing and architecture.
How to check vortex flow meter is in good condition while we do not having calibration setup?
send me last 5 years questions asked in rrb chennai, for section engineer
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
Explain an adaptive / self-tuning controller’s major draw card.
diff between neutral ,ground,phase , earthing and shielding?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
Explain the working of rota meter.
What is mean by analytical instrumentation?
How to Calibrate Level Troll in field
