Answer Posted / sarath naryan nair
For slabs = 1.0 % of concrete volume.
For Beam = 2 % concrete volume.
For column = 2.5 % of concrete volume.
| Is This Answer Correct ? | 34 Yes | 2 No |
Post New Answer View All Answers
how we check the thickness and line of ceiling plaster.
List out some of the software used in the construction sector to estimate cost and monitoring expenses?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
How many are the types of joints?
how i can tak Quantity of mortar in block work
What are the skills required to become an architect?
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
If u want ur Ans.Of any Question so mail me skatiyar011@yahoo.in
For plate load test why we are applying pressure 3 times the proposed allowable bearing pressure? Is there any supporting standards for this?
What is the difference between shear and tensile strength?
Why are separation membranes used between concrete pavement slab and sub-base?
how u design STAGING for Superstructure in BRIDGE construction?
sir, please send me the web address of chennai railway to know the online examresults of junior engineer[civil].
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
what is Bearing Capacity,How to determine it?
