Interested to Buy Any Domain ? << Click Here >> for more details...
What is an analog input-output
- 10 Answers
- 61800 Views
- TN, Torrent Pharma, I also Faced
- E-Mail Answers
Answer Posted / mike
Analog input is the signal that a building automated system is telling a device or motor to do. The analog output is what the device or motor is actually doing. So let's say your Building automated system is telling your air handler main fan to run at 20%. That's your analog input. Your analog out put should be the same 20% signal from the controller and you fan should be running at 20%. If your input is 20% but your output is 0% and the fan is not running chances are you have a bad controller or there is a safety device that is preventing the controller to send the 20% output to your fan motor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
How to Calibrate Level Troll in field
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
What is loop1 and loop2 in MTS LT?
What is three element drum level control system why its better than single element?
What is force balance principle? State some of its’ advantages.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
how to commission furnace ( water heater)
Why even multiple power supplu r used in instrumentation system?
