Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karuna karan
Motor alignment is to check motor shaft coupling to pump or fan shaft coupling free rotation with axial and radial direction with the dial gauge clearance of all the 4 angles 0° , 90° , 180° , 270 below 0.05mm (50 microns). And also to check the coupling gap as per general arrangement drawing and also to check bearing clearance of both DE and NDE.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why the output of OP-AMP is always less than Vcc?
how we can explain arc heatng?
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
What is the significance of integral controller and derivative controller in a pid controller?
how to calculate current and voltage in a same circuit?
Alternator rotor earth fault relay circuit
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
IN 1000kva transformer where the oil and winding temperature sensors is connected
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
What is the efficiency during maximum power transfer?
why dimmerstate always connected in star connection? what will happen if it connected in delta?
What is the difference between DOL starter and star delta starter
