why are use corona ring in high tension line switchgear?
- 1 Answers
- 2824 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghu
In the HT switch gear should not be use sharp/rough conductor to reduce the power losses in the line, when we are using corona ring (having smooth surface) it may reduces the power loss and corona effect.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
What is the magnetic field (coil DC ) of Turbo Expander?
CBCT selection
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
How to calculate the sag on transmission Lines.
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
please send me previose rrb junior engineer qustion papers
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
why and how voltage sharing in transformer, during magnetic balance test ?
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
please send me previous year questions of jspl through which i could prepare myself for the test.
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
