Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rahulcnbc
Poor air balancing, low RPM in the AHU...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which reactor has no moderator ?
What is the Self & starter? what does it do in the in Genset
What are the modes of heat transfer?
What is the difference between Muff Coupling and Screwed Coupling with Cotter pin used in pump line shafts.
Contaminants of fuel oil
What are two essential conditions of perfect gas ?
What is Lap welding?
What are the procedures in paralleling D/G?
difference between internal energy and enthalpy?
What is maximum continuos Rating?
I HAVE SELECTED INTERVIEW FOR GOVT POLYTECHNIC LECTURERS.I DONT KNOW ANYTHING.PLZ HOW INTERVIEW WILL GO AND WHAT QUE'S SUPPOSE TO ASK ABOUT SUBJECT.PLEASE SEND QUE'S AND ANSWERSTO MAIL OR CALL THIS NO:9966924990.PLZ HELP ME.
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
what is the difference between pipe and a tube?
Hello there, Im a Mechanical Engineer. I passed out in 2010 and have worked for 6 months in the Middle East as a Trainee Engineer. Im now in India and due to appear for an Interview for a firm in the Middle East. The post is of an Automobile Engineer. Im kinda nervous as to what to prepare for the interview. The training which I got was in different areas ranging from technical to managerial aspects. What I mean to say is that that was more of a crash training, where I couldn't stick to one section alone. The interview which Im attending is more of a technical one. What I would like to know, how and what I should be preparing? I have two weeks for the preparation. Should I go through the normal automobile aspects or everything in random. PS: I have excellent communication skills, the one area in which I'm very confident.
what is the difference between set up of cast iron manufacturing industry and steel manufacturing industry?
