which type of A.C motor is used in the fan (ceiling fan,
exhaust fan, padestal fan, bracket fan etc) which are find
in the houses ?
- 25 Answers
- 68708 Views
- Airtel, MPPTCL, USSA, I also Faced
- E-Mail Answers
Answer Posted / binit kumar shaw
Permanent capacitor type induction motor is used...
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
Explain how you intend to work under pressure to meet up with deadline target?
Determine the BTU size of an aircon for 20 sq metre room
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
specific difference of ICT&Auto Transformer
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
what is EIB lighting control system? what is the advantages of this system?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
Define ohm’s law for a.c (alternating current)?
What is transformation ratio what it describes?
When we connect the large capacitor bank in series ?
What type of fittings and electrical accessories can be install in radiation area ?
What is the disadventage of gland earthing(power cable) if any. ?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
