Interested to Buy Any Domain ? << Click Here >> for more details...
what is the CT of protection and CT of metering ? what is
class 5P10 & 5P20 and class PS ?
- 16 Answers
- 130357 Views
- JEE Main, ONGC, VRA, I also Faced
- E-Mail Answers
Answer Posted / kkmurty05
MrTahir Vora,Reliance Jamnager has said that CT will give 5% ratio error.
(1).It is not ratio error alone but it is the composite error.
(2)The definition of ALF is no doubt correct for rated burden,however ALF increases if the total connected burden is less than the rated burden.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the power factor of an alternator at no load?
how to calculate short circuit current for the busbar
What is difference between insulating medium and fault current interruption medium in a switching device.
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
Which do you think is the most significant cause of energy loss in a factory?
What are reasond for high wattage in single phase induction motors
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
what are the different methods for the starting of a synchronous motor.
What is the difference between PLC and Embeded system
please give me solution to rectify the emi(electromagnetic interference)
how to check regenerative load in drived motor
