CHEMICAL ENERGY BALANCE - EXAMPLE 11.2 : Calculate the cooling duty, H required to condense and cool acetone from 100 degree Celsius to 25 degree Celsius at atmospheric pressure. The heat of vaporization for acetone at its normal boiling point is 30.2 kJ / mol. The boiling point of acetone at atmospheric pressure is 56 degree Celsius. The flowrate of acetone through the condenser is 100 mol / s = N. Value of sensible heat needed to increase the temperature of acetone in liquid form from 25 to 56 degree Celsius is 4.06 kJ / mol. Value of sensible heat needed to increase the temperature of acetone in vapor form from 56 to 100 degree Celsius is 3.82 kJ / mol. Unit of H is kJ / s.
Answer Posted / kangchuentat
CHEMICAL ENERGY BALANCE - ANSWER 11.2 : In the same state, total heat changes in heating = total heat changes in cooling for acetone. H = N ( total heat of sensible + heat of vaporization) = 100 (mol / s) [ (30.2) + (4.06 + 3.82) ] (kJ / mol) = 3808 kJ / s. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain what information is needed to specify a mixer?
Are there any general rules that should be considered when designing a slurry piping system?
Oil and fat containing food items are flushed with nitrogen. Why?
How can hexavalent chromium be removed from aqueous waste streams?
How can arsenic be removed from aqueous waste streams?
i am a prefinal year student of polymer engineering .could you please send the latest question papers regarding entrace exam.
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
In which state sulphur exists at 40 degrees temperature and 40 atmospheric pressure in natural gas having sulphur composition 0.1 ppm?
can you explain about the design calculations and procedure of boiler
I am a Diploma Chemical Engineer by Nirma Uni; and BEng (Hons) Energy & Environmental Engineer by Napier Uni; Edinburg, UK. HPCL chemical engineering test will held on 14th July,09. So, Please send me some previous chemical engineering papers Objective types Or material to give the test.
What compounds are responsible for the odors that come from wastewater treatment plants?
Difference between Synthetic foaming agents V/S Protien based foaming agent?
Are there flow velocity restrictions to avoid static charge build up in pipelines?
What are some common causes of control valve noise?
How much waterproofing compound in one Sqm Plastering (thick.12mm)