CHEMICAL ENERGY BALANCE - EXAMPLE 11.1 : Please match the term A - E with the stated definition i - v. Terms : A. Yield. B. Selectivity. C. Relative saturation. D. Molal saturation. E. Absolute saturation. Definitions : i. (moles of desired product formed) / (moles that would have been formed if there were no side reactions and the limiting reactant has reacted completely); ii. (moles of desired product formed) / (moles of undesired product formed); iii. (relative humidity 40 % means partial pressure of water vapour equals 4 / 10 of the vapour pressure of water at the system temperature); iv. (moles of vapour) / (moles of vapour dry gas); v. (mass of vapour) / (mass of dry gas).
Answer Posted / kangchuentat
CHEMICAL ENERGY BALANCE - ANSWER 11.1 : i. A (moles of desired product formed) / (moles that would have been formed if there were no side reactions and the limiting reactant has reacted completely); ii. B (moles of desired product formed) / (moles of undesired product formed); iii. C (relative humidity 40 % means partial pressure of water vapour equals 4 / 10 of the vapour pressure of water at the system temperature); iv. D (moles of vapour) / (moles of vapour dry gas); v. E (mass of vapour) / (mass of dry gas). The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How can you control the ph level in our cooling water with respect to ammonia contamination?
Are there any alternatives to scraping a shell and tube if a capacity increase will make the pressure drop across the exchanger too large?
Hi.. Me going to tke test for management trainee(technical) Post I am an chemical engineering student . Can u guide how to prepare for this test.Can u send me test paper pattern..?
What is the procedure to estimate the friction factor involved in heat exchanger tubes?
what are the chemicals used in PFR and MFR to Process?
Hallow everybody, we want to know in a NPk fertilizer process plant (Bulk Blender) we are in doubt if use square or rectangular hopper jus to avoid the vault effect durin the flow of of raw material like Phosphorus, Potasium and zeolite..Please any advise will be appresated Isdray
What is the use of gear pumps in motor?
How can you determine the largest impeller that a pump can handle?
repected sir i have given gate exam today.......... if i ll get the better rank in that ....what is the next process .....shall i give another one test......or wat....i dint get properlly..... plz help me or mail me on Nish_gasti@yahoo.co.in
What are the reasons of removal of particles from effluent gas?
which materials can l use if l want to use length wave 680 to 900 in hplc
Explain what are the disadvantages of using gear pumps?
Define an additive?
How do you design a vapor-liquid separator or a flash drum?
Explain what information is needed to specify a mixer?