Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of restraining coil in differential
relay? as well as restraining current?
- 8 Answers
- 46601 Views
- Medical, Siemens, I also Faced
- E-Mail Answers
Answer Posted / vikash kumar barnwal
restraining coil is given to avoid mal-functioning of differential relay.
since differential relay works on the principle of balancing the incoming and outgoing currents from alternator coils and due to the inductive effect of alternator coils, there is some phase angle difference between these currents..
so even there is no fault it may cause to operate the relay coil.
hence, restraining coil is given to limit the sensitivity of the differential relay.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
why we used ZNO in Lightning arrester.
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
Why line VTG = √3 phase VTG in star? How?
why we change the direction of winding in rotor ?how we make the north and south pole?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
how to enter inverter parameter? without manaual?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
Why increase in current leads to increase in conductor temperature?
What is load boxes ?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
State kirchoff current law?
