what is the function of a commutator in a dc generator?
- 14 Answers
- 71945 Views
- College School Exams Tests, NTPC, TCS, I also Faced
- E-Mail Answers
Answer Posted / francis madukwem
A commutator is device which changes an Alternating current to a Direct current.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why only exciting current is shown not primary current in transformer???
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
how to handle 2500 kva transformar
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
What is the unit of attenuation?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Define relative stability.
what is the principle of operation of tungstun bulb ??
physical identification of HT & LT panel
Difference between On Line capacitor and Station Type capacitor.
What is MS-EXCELL?
Can you explain about TEE protection scheme?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
