Why generator field rheostat is set to maximum position and
motor field rheostat is set to minimum?
- 5 Answers
- 41973 Views
- Bhel, College School Exams Tests, TCS, Texas, I also Faced
- E-Mail Answers
Answer Posted / ram
Field rheostat is in minimum position because of the motor runs at a rated speed. If the field rheostat is maximum position the motor runs at above the rated speed
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
What is the comparison of PILC and XLPE cable
What are the causes for the failures of sandwich type (Al) busducts?
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
What are the material used for inductance coil?
dg earth connect only in the amf panel or not why
What type of DC motor would you see for a lift?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
hi,every one, i have to write the search paper on "performance policy optimization" of NGN (next generation networks). i need the material on this topic. can any body help me. please tell me any useful site where the good material is available and name of any reference book. it should be a great help for me.
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
hi every body i am master student in control engineering and my project is slip control in trains i assumed a Dc motore as traction motor but i don't have characteristics of this kind of motor that is used in train. i want from every body if he or she has the characteristics or information about Dc motor that is used in train give me those information or technical characteristics .
What is the main purpose of c.f.b.c.boiler
What are the basic & Majour problems in UPS ?
what is maxemo work permit procedure
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
