Interested to Buy Any Domain ? << Click Here >> for more details...
How to Calculate Stc Rating of an indoor type VCB Panel?
What is a full form of STC?
- 1 Answers
- 14480 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / vipul parmar
STC Means Short time current. it s calculated from transformer Impedance.
there are difference stc rating like 18.3ka ,26.3ka ,31.4ka ,40ka.
Electrical Power Systems in industrial plants are designated to serve loads in a
safe and reliable manner. One of the major considerations in the design of a
power system is adequate control of short circuits.
Three-phase short circuits usually produce the highest magnitude of current the
power system equipment must be able to withstand. Phase to ground short
circuit currents might occasionally be higher than three-phase short circuits
currents in systems with multiple-point solid neutral grounding. In general,
power systems in industrial facilities, which employ single-point solid grounding
or resistance grounding, require only a three phase fault current calculation to
determine current magnitudes for proper fault interrupter application and for
protective device coordination studies. However, this study considers also the,
phase to phase, phase to ground and phase to phase to ground short circuit as a
reference.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is through fault?
Why LED light has advantage of rapid reflection ,although other lights alse reflect.? and this light is considered to be best for transmission usage in case of Free optics
Air refrigeration cycle works on the
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What are the different power system losses and how can it be eliminated?
what is meant by motor startup supervision & motor load jam protection ?
What do you mean by Frame 5 Gas Turbine as well as Mark II.
Which cable is use for rtcc control panel
In a single how much maximum current and watts using
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
What are the effects of electrical faults?
what is RNG in the DG synchronizing by PLC?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
how can i get an electrical c-certificate?
