why we use DO Fuse in H.T. Line ? What is the purpose of
DO Fuse
Answer Posted / k.sudheer
DOLO fuses-
1. Avoids loose contact due to spring loaded 'clip' system to the stationary upper portion.
2. Once fuse is blown, the fuse rod 'hangs' down (since the sprint latch was ties by the fuse
wire itself.
3. blown fuse rod can be removed without 'line clear' by using a 'fuse link rod'. Fuse is the replaced at ground, and again using the fuse line rod, install back- "click" the top latch holds.
4. The DOLO fuse rod is a hollow tube of Mica sheets to prevent molten fuse wire from splashing out.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
DG cranking voltage?
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
what is mean by parallel operation of permanent magnet generators
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
What is the most important precaution in any experiment with d.c. Shunt motor?
I am EEE student i want to improve my core side skills.how cn i approach it?
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
what is the main difference between power devices and signal devices
What is synchro?
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
what is the difference b/w ATS and HTS?
we have a rewind motor of 2Hp,2800Rpm, 220Volt AC. how can we choose the running capacitor for this motor, any formula for that?