could any one explain me what power factor and where it is
use ful
- 3 Answers
- 4178 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswa
Pf is the co sine angle between voltage & current,it depends on kind of load ,if the angle is more gen "ll hv more current(actual +reactive current) un necesserily(kvar),which means same load more current,causes overheating of d/g,in case of comparatively less load over current trip will occur.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can we choose the rating of submersible motors
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
why co incidence factor considered in transformer sizing?
operation of diesel generator
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Why frame of the motor is specified?. If we mention KW and voltage level,automatically frame is decided or separately frame is compulsory to mention?.
what is differentila pilot supervision in the incomer control panel in the power station?
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
why only exciting current is shown not primary current in transformer???
