Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suresh
My pressure transmitter range is
-1 to 17 bar. Pls explain in simple way linear scale with formula.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
How ejector(or)evactor air pump is working in thermal power plant?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
How to work temperature gauge?
wich is coming the first HAZOP OR SIL
What is hp & mp seperator .& what is its working principle ?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
where proximity sensor installed on tank in loading arm application
how to calibrate Necleuonic level transmitter.?
What is the basic difference between Modbus and CAN Open Protocols
