Interested to Buy Any Domain ? << Click Here >> for more details...
How the Oil Surge Relay works? How it protect the OLTC?
- 3 Answers
- 55925 Views
- JSL, I also Faced
- E-Mail Answers
Answer Posted / satish raman pathak
It is a gas operated relay.It is placed between Main Tank & Conservator Tank,with an angle5-7 Degree.There are2 Mercury switches, one in the top & other in the bottom of Bucholz relay,filled with Transformer Oil. When small amount of vapour passes through the relay Top Float will operate, gives Bucholz alarm.In case of heavy internal fault, Large amount of Bubbles forms,operates the Bottom Float , Gives Bucholz Trip.In case of Bucholz Alarm/Trip Relay contact to checked first(IN Alarm/Trip Relay contact will change).then if there was any gas formation occured.Gas should be relaesed through the top Vent of relay( in that time hissing sound is observed in case of Gas present).Have to release all other top vent in Main Tank & Radiator Top.
In case of OLTC, there are saperare OLTC Surge Relay, same as Main tank Bucholz Relay.
After gas release if Trafo again tripped in Bucholz.Then there must be some hot spot/heavy internal fault in Trafo.other necessory testing to be carried out, like Ratio test,Magnetic Balance test,Vector group test,IR Test for further fault finding.
| Is This Answer Correct ? | 3 Yes | 10 No |
Post New Answer View All Answers
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
difrent between vcb acb sf6 and mccb breakers
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
what are the different methods for the starting of a synchronous motor.
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
What is time invariant system?
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
why dc is used in control circuits for MV & LV switchgeras instead of ac
limitation of conductor height on ground when we consider EMC
what are the steps involved in generator load test?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
What is the difference between earthing,ground&nutral?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
Define average demand?
