Interested to Buy Any Domain ? << Click Here >> for more details...
in a diesel generator is there any relation between AVR to
fule system?
- 2 Answers
- 4464 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.v.selvan
No relation b/w fuel but it's used in genrator pannel board
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
how to calculation increase power factor for single phase
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
what is the requirement regarding earthing of Single conductor with AWA
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
how to design coil turns ?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
what is booster? and how it is connected in a circuit?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
