why circuit breaker closing time is always higher then
tripping / opening time.
Answer Posted / krishnakumar
The circuit breaker is used for protection purpose and the main function is to trip(open its contacts) when relay gives the trip command.the tripping of breaker will isolate the healthy phase from faulty phase.if the tripping time is more t,then the fault will be present for more timing and this will damage the whole system.so the breaker should operate at high speed in order to protect the system.so,the tripping timing should be less.but in case of closing of breaker,there is no need as such as tripping at fault condition.and there is another phenomenon called bouncing that makes the timing increased than tripping time.if the timing is less for closing,then the breaker moving contact moves very fast towards the fixed contact and so the bouncing will be more due to the high speed.this is also a reason for more closing time
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
can someone explain that how the speed of the protection system affects the fault level calculation?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
what is the relationship between current&voltage in practical purpose ?
if i am in front of transmission line how to know that current direction without any equipment
What are the advantages of hydropower?
what is the meaning of impedance protected in instrument cooling fan
What products have you designed which have entered high volume production?
what are the Alarm, Trip & Safety equipment (Issues) present in Power Transformers pls Mail it to ashokbabunhce@gmail.com
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
How can I known multiplying factor .without multiplying table
what happens if dc supply is given and the remedies for it.
How can we calculate the motor frame sizes?