How to calculate the amount of Brick,cement & sand required
for 1 cum of 230mm thick brick work with ratio 1:5 please
give me an answer with detailed step
- 31 Answers
- 304340 Views
- Assurance, Design Ideas, Jeno Maran Builders, Lanco, NamPower, NCC, Prime Adhivas Contrats, Simplex, SSM, SSM Builders and Promoters, I also Faced
- E-Mail Answers
Answer Posted / anil shinde
if we consider brick size 230mmx150mmx80mm thk,
requrired brick qty will -215 nos,considering mortar thkness will 12mm .
total mortar area-.407cum for 1cum area brick masonary
therefore brick area will 1cum-.407cum=.592cum
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
An interior designer designed a rack with the given dimensions. The dimensions are in feet. This coplanar frame repeats at every 5feet and constitute a space frame. The total length is 120feet. Which steel member will you suggest? A square bar, A square tube or a circular tube. Explain.
at what pressure ply-wood is obtained by gluing wooden sheets
What is specific gravity???
could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!
How to decide/consider the grade of bitumen for dbm.
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
if the nitrates more than 45mg/l in water lead to disease then what is it called
Advantage of Aluminum form work in terms of activities can be skip and cost too
What is the l/d ratio of cantilever beam?
What applicable rate of wct in bihar
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
what is w/c ratio in dry lean concrete for m10 mix design
2nd and 4rt angle elevation used in which country ?
how do you calculate the length of "L" of main & distribution bar for reinforcing of raft footing
sir how can we find the cement and sand required for making 4" drop
