Answer Posted / varun devulapalli
basically harmonics are the distorsion in the system waveform. these may lead to the poor sine wave and hence the system performance is effected. Harmonics are of two types : even harmonics and odd harmonics. Compared to even harmonics odd harmonics are very dangerous. if in a one half cycle of the main wave there are 3 half cycles, then it is 3rd harmonic. and similarly if in one half cycle of the main wave there are 5 half cycles, then it is 5th harmonic. the above said are odd harmonics. similarly for even harmonics, there will be even no of half cycles for each half cycle of the mainn wave.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
briefly explain principle of resistance welding
can any tell me why slope 40% and 80% is calculated in differential protection?
can i use 2000/5A Clamp meter to measure HT cable
State ohm’s law?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
For overhead protection we use which transformer?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
CBCT selection
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
What Is Sampling?