why CT ratio stand for 50/5, 100/5, 25/5.
Answer Posted / yash
CT- Current transformer basically design for metering and sensing purpose .and KWH meter basically design for capacity around 5 A . So CT always available in ratio 5 A.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
Why use the vcb at high transmission system ? Why can’t use acb?
what is maxemo work permit procedure
what is mean by descripiency relay? & wht is its ansi code?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
How calculated single phase induction motor req. Capacitor?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
how to build a network which step down 415v to 1v rms
State kirchoff current law?
What is gross error?
how is find out kwh step by step
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
What is the accepted limit to increase the choosen transformer capacity over the load and why ?