in railway engineering, what are the types of guages? what is
its size,length & thickness?
- 6 Answers
- 9432 Views
- I also Faced
- E-Mail Answers
Answer Posted / kuldeep gorsi
1)stand. gauge 1.435 m use 67% all over the world
2)broad gauge 1.676 m
3)meter gauge 1.0 m
4)narrow gauge 0.762 m
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How do you calculate load bearing capacity of a waffle slab?
Design a reinforced concrete combined footing (rectangular) for two columns located 3.60 metres apart. The overall sizes of the columns are 40cm x 40cm and 69cm x 60cm and the loads on them are 1000 kn and 1500 kn respectively. The space available for the width of the footing is restricted to 180cm. The S.B.C. of the soil is 280 kn/mm2 use M15 concrete.
Explain the Strength of brick?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
how many material required for brickbat water proofing of toilets.
how can we calculate steel value, depending on load
What happens when water mixed with cowdung is used for priming instead of water for lifting water in pumps?
what is E
What are the different methods for drawing an arc?
what is the water-cement ratio of mix design while 30mpa in 7 days?
60-70 grade of Bitumen is VG-30 ?
the water is flowing through a velocity of 1.5m/s in a pipe of length 2500m and dia 500mm. at the end of pipe a valve is provided. find rise in pressure 1. if the valve is closed in 5 seconds. 2. if the valve is closed instantaneously. take value of c = 1460m/s, pipe to be rigid and bulk modulus of water - 19.692x10' n/sqcm
Why Should Curing Not Be Done By Ponding And Polythene Sheets?
Which tests are performed on soil to decide the type of foundation to be provided.
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
