We have 11kV/110V three phase indoor potential transformer in 66/11kV Sub-station, where the failure of PT is frequently happening and the rating of the PT is 0.2 class accuracy, with primary star and seconday (two cores) star connected.
Some experts has suggested to not to connect the PT Primary neutral to the ground because when transformer neutal NCT connection is loose; the faulty current will flow through the PT primary neutral, resulting into failure of PT.
My question is: Is it necessary to remove the primary neutral connection of the PT from ground? if not, what would be the reason for failure of PT.
Please guide me.
- 2 Answers
- 2809 Views
- KPTCL, I also Faced
- E-Mail Answers
Answer Posted / karthikeyan
hai mr.gokul,what kind of failure in pt,please tell me.i will clear this problem..,
regards,
karthikeyan
+919095206722 (whats app)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate the settings for shaft ct protn in hydro generators
why do we not use equivalent voltage source in negative sequence equivalent ckt.
What are the operation carried out in thermal power station?
how can we find thae value of capacitor for single phase motor. what is difference between starting capacitor and running capacitor.
Why saturation region slowly shifted in the left side?
How to synchronization will be done between two DGs ?
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
what is the meaning of neutral displacement ???
what is the difference between pvc & fiber glass cables
What is the difference between electrical earthing and electrical grounding?
how to read idmt curva
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
