Answer Posted / raju
any and all forms of opposition to electron flow
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
Fantio of tranformer
How to setting the volume of RTCC panel AVR (11kv) controller
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
Direction of flow of active power and reactive power with logic?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
show the single line diagram of star delta starter with single phase preventer
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
why we used dc supply for field in dg set
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?