Interested to Buy Any Domain ? << Click Here >> for more details...
why high pressure heater will take after sufficient pressure?
what happen when high pressure heater will take from COLD
REHEAT line at light up time when hp and lp by pass in
service.(means can we heater take at low pressure?)
- 2 Answers
- 5188 Views
- I also Faced
- E-Mail Answers
Answer Posted / chetan h malaviya
We can take CRH extraction line(HPH 6) in line during lit up but at that time pressure of CRH line must be >5 kg/cm2 and corresponding degree of super heating must be >100 'C
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
what is natural frequency of turbine shaft .
By any way can we increase the B check hours from 300 to 500
How We Calibrate the vaccum transmitter?
procedure of how to generate power in solar plant.
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
Why superheated are started before I'd and rd fan?
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
what's the moog valve
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
what is the basic use of power plant in equipment
why do you consider yourself a suitable candidate for this position
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
