can we use heat gun instead of gas torch in 11kv termination kit. I mean can both sources provide enough amount of heat to ensure the uniform shrinkage of sleeve.
Answer Posted / dadaso patil
Yes, we can use both of device for cable sleeving.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
What is miller crystal oscillator? Explain its operation?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
working of diesel generator ?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What does quality factor depend on in resonance?
whats the application of voltage regulation? and whats the voltage regulation's device?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
difference between Ac and Dc mcb ????
What is the most accurate way of testing ELCB?ELCB is better than RCD?
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
how can motor both beasrings insulation resistance can be check?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?