Interested to Buy Any Domain ? << Click Here >> for more details...
does the compressive strength of brick be more then 3.5
n/mm2 or 5 n/mm2?
- 3 Answers
- 8336 Views
- L&T, Modi Builders, I also Faced
- E-Mail Answers
Answer Posted / avnish
highest compressive strength of brick is 14N/mm2
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
How much sand and cement requirement for 1 SQM 125mm thickness Brickwork
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
Which is the indian standard code of line out. ? How much tolerance fot 1 mt lenght? Its challenge....
What is an object snap mode?
I am a civil engineer . I am also selected for sbi clerk interview which is to be held on 4th May2010 is there anybody resembling the same? what question can be asked and what should be the probable answers?
what is the mix design for M:60 with micro silica andmetakaoline?
how much is the maximum compressive strength of soil cement and soil-cement-microsilica .
sir please send me campus placement questions in civil engineering
how much need cement bags for block work of wall approx 1000 hollow blocks 20x20x40cm
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step
Pls explain me about tension and compression in a flat slab
What is the meaning of Brick- M 35 grade? Is it a common brick or it's a concrete brick?
I want to know about rolling margin of steel :- For eg. If 2nos. bundle of 8mm dia steel with17 rods each of length 12m comes to store. During testing of 1m rod of each bundle it was found that 1rod has weight .405kg/m while other has .385kg/m. Now what will happen in case of steel payment and measurement payment ? Regards,
How do you compute moisture correction using the parameters gathered from Nuclear Density Gauge Apparatus and the moisture contents results from the lab.?
