What is the spacing of chairs in reinforcement steel.If it
is written in IS 456:2000 then tell me the page number.
- 2 Answers
- 6561 Views
- I also Faced
- E-Mail Answers
Answer Posted / protin rabha
At 1 m. Page no. 27, clause 12.3.2
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to arrive d*d/162 , for finding the kg per meter , wt of steel
is there any codal provision for soil cousion over the Hume pipe of Dia 1.2 m.
Explain major difference between auto level and dumpy level?
how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress
Why joints are provided?
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
what is the function of GSB all class ?
Explain what are the problems one might face while having a Cantilever balcony?
How to testing voids of filled aggregate in bitumen mix design
What is the snap size in civil and how can we create it?
Can a wave happen in the middle of the ocean like in the movie poseidon 2006?
in the construction of residential building what type of tank are used?where?why & what is its purpose?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
how much cement and sand required for 100sqm of wall plastering in different proportions
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
