Clearly Define Active,Reactive,Apparant power.Which
applications used which power above metioned power?
- 9 Answers
- 21145 Views
- Summit Power, I also Faced
- E-Mail Answers
Answer Posted / mannysood
Real power is actual power for exp heating lighting
rotating and reactive power is used for excitation purposes
of winding of transformer generator and motors
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
What is meant by harmonic distortion?
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
what is the function of gss in the dg set.
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
whats the differece between Exd and Exe
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What do you understand by avr?
what can be the causes of capacitor start motor having a higher current that its actual
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
What does quality factor depend on in resonance?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
what are the Alarm, Trip & Safety equipment (Issues) present in Power Transformers pls Mail it to ashokbabunhce@gmail.com
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
