How many kilo of binding wire required for one ton of reinforcemet steel binding?
- 17 Answers
- 19630 Views
- ECCI, L&T, Shri Janani Homes, I also Faced
- E-Mail Answers
Answer Posted / esantharaj.c
mostly using one tone binding wire=8kg
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Moisture content calculation for diff mix ratio's ??
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
If we buy crush sand for 3200/ Brass and cement for Rs350 /Bag and flyash 1200 / tonne....and my production is 230 Bricks per bag than how much cost is required for 1 flyash brick?
why are you joining in this (applied post) job and your aim for this job
hi, i am appearing in HPCL(CIVIL ENGG.)exam. plz send me placement paper of this exam if u are having
where can i get the previous question papers for rrb section enginerr (civil)
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What is the Tor steel Consumption for residential building G+24 footing (thum rule) ?
Sir how to find cutting length for footing steel bars in the shape of "u"
What is the use of offset command?
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
What are the alternate material for steel, Sand and aggregate
Sometimes the side of concrete bridges is observed to turn black in color. What is the reason for this phenomenon?
how to identify np3 pipe and np4 pipe
