why we are using (-24VDC) and where we r using plz tell me
Answer Posted / asif.k64@hotmail.com
In telecom Industry, Telecom devices use -24 Volts DC, as positive terminal is grounded.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How we calculate orifice plat size???
How to calibrate the flow transmitter
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
How oil line flow measured?eplain about instruments used and working principle?
What is heating effect?
What is Predictive Maintenance
What is stripper & spilitter ? Diffrence in this.?
Explain the mechanism behind the turbine meter.
please send data bank of quetions answers on analytical instrumentation.
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Operational amplifiers
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters