Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using (-24VDC) and where we r using plz tell me
- 7 Answers
- 7718 Views
- I also Faced
- E-Mail Answers
Answer Posted / pandu
mugil ji your answer is correct and one thing in plc, is it possible to use -24vdc
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
Why plc require in analog input 4-20amp & 0-10 volt?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is instrument philosophy
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
can u briefly explain aboutan aryton shunt multirange DC ammeter?
how to check earthing,what is minum ohms for proper earthing
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
How many are the types of instrument cables in terms of No. of pair.
what is the protection system in solar turbine compressor
how to calibrate load cell
how to calibrate corollaries (Mass flow meter)?
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
