Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ali
630A TPN ISO and 125A,25KA TPN MCCB
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
Instrument connected to a single phase supply
what is the ATS .And how it works.
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
Usage of flywheel diode in relays
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what is the effect of un-synchronized power.
how external lighting design? please give examples?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
