Interested to Buy Any Domain ? << Click Here >> for more details...
why CT ratio stand for 50/5, 100/5, 25/5.
- 11 Answers
- 68843 Views
- ABB, Ramky, I also Faced
- E-Mail Answers
Answer Posted / neeraj duklan
Generally allThe CT operated meter is designed for a
capacity arround 5 A , the ct ratio 50/5, 100 / 5 means the
secondary current of the secondary winding will not exceed
more than 5A
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How does a transformer contribute towards the widespread popularity of ac system over dc?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Why air circuit breaker off due to power failure?
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
how much allowable resistance that can be difference in motor all coils?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
how to calculate the no load current in transformer?
Why derivative controller is not used in control systems?
Define cuttoff frequency?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
what is 30-phase of transformer
