Interested to Buy Any Domain ? << Click Here >> for more details...
transformer is connected with 50hz and 60hz at same rating
which will give more output on same rating
- 2 Answers
- 4221 Views
- Palace Consultant, I also Faced
- E-Mail Answers
Answer Posted / mac rana
I think 50 Hz transforme will give more output because eddy current and hystersis directly depends on frequency and in large frequency it would be large and reduces output
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
HOW WORK HEAT PLATE EXCHANGER
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to calculate the no load current in transformer?
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
how to calculate the settings for shaft ct protn in hydro generators
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
what is ratio of copper wire size and current ?
how to find the multiplication factor for digital energy meter and analog energy meter
What are dependent sources?
Can you explain about TEE protection scheme?
What is notching in dc machine?
how to carried out tan delta test in 11 KV alternator ?
