Answer Posted / abdul rehman

Ai means analog input which goes to dcs from control valve or pt or lt and any instrument which opperate to analog signal 4 to 20 ma.
Ao means analog output which goes to valve from dcs madules in 4 to 20 ma.

Which is your favourite subject & explain any one topic of it.

9600

---

can we copy the software from a transmitter using hht(hart 275) ?

2077

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

1673

---

describe flow nozzel principle?

2521

---

Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions? 

2186

---

please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...

1979

---

can any one explain in which term we are flow flow is it volumetric r is it mass? and y

1939

---

what is temperature compensation?

5444

---

what is the importance of CV in the control valves? how it is calculated?

2444

---

What is difference between ESD and PLC please Explain me clearly.

4892

---

if in a level tx height is given, how u calculate the ranges of the tx?

7728

---

what effects a surging can produce in the compressor

1918

---

In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?

2075

---

Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in

1940

---

In turbine what does term CDP, NH, HSSOC means.

1772

---