Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anuj kumar
To convert ht amp to Lt apm we use CT which reduce amp which depende on ratio then ct secondary wire we connect to ampere meter .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
start-up procedure of a centrifugal compressor
where is floating bearing located?
What causes little rust pockets to pop through or off concrete cylinder blocks (home)?
How three wire proximity can be used in place of two wire proximity?
Distance to be maximum distance we can install instruments from PLC panel?
How the costs of the products and throughput time can be reduced while handling materials?
What are the areas where I need to make improvement? (Please provide examples and suggestions for improvement).
why we give dedusting steam in feed gas coils in convection section of primary reformer?
We will import machihery. how we will take input
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
what is difference between an encoder & resolver?
How does pressure transmitter electronics sensor be used to transmit level measurement parameter?
how can LED bulb indication work correctly without CT OR PT for 3 phase indication if one is cut then it will show the correct indication?
I have 200kg weight cylinder,I want to rotate,but i don't know what is torque of cylinder and what's size of motor for rotate the cylinder.i want to know calculations find out torque of cylinder.
what is the need of rectifier?
